Canon LBP6680x E-Manual page 897

Solution 2
Not enough spool memory. <Auto Error Skip>
<Cause> Because spool memory ran out, the printer cannot print.
Solution 1
Solution 2
Solution 3
Solution 4
Solution 5
Not enough system memory. <Auto Error Skip>
<Cause> The work memory required for the printer process ran out while the system was processing
the data (mainly the graphics data and text data).
Solution 1
Solution 2
Not enough work memory. <Auto Error Skip>
<Cause> The work memory for each print mode cannot be secured.
Downloaded from ManualsPrinter.com Manuals
Downloaded from www.Manualslib.com
printed correctly.
If images such as Progressive JPEG are handled inside the XPS, convert them to TIFF or Baseline JPEG
and then print.
Press [ ] ( : Online) to continue printing. However, the page with which an error is occurring is not
printed.
Perform the following procedure.
1. Perform a soft reset.
"Canceling the Process Currently Being Performed (Soft Reset)"
2. Specify the paper size smaller, and then print again.
Perform the following procedure.
1. Perform a soft reset.
"Canceling the Process Currently Being Performed (Soft Reset)"
2. Set [Gradation Level] to [Standard], and then print again.
"[Setup] Menu ([Quality] Options)"
If [2-Sided Printing] is set to [On], specify [Off], and then print again.
"[Setup] Menu ([Paper Source] Options)"
Change the setting for [Halftones], and then print again.
"[Setup] Menu ([Quality] Options)"
Press [ ] ( : Online) to continue printing. However, the data with which an error is occurring is not
printed properly.
Perform the following procedure.
1. Perform a soft reset.
"Canceling the Process Currently Being Performed (Soft Reset)"
2. After the soft reset, either perform a hard reset or turn the printer back ON, increase memory
capacity and print again. (All data in the memory will be erased.)
"Canceling All the Jobs (Hard Reset)"
Press [ ] ( : Online) to continue printing. However, the data with which an error is occurring is not
printed properly.
manuals search engine