Table of Contents
Advertisement
When using DHCP
If you cycle the power of the printer, you may not be able to print. This is because a different IP address from
the one that has been used is assigned.
When using DHCP, consult your network administrator and perform either of the following settings.
Specifying the DNS Dynamic Update function
Specifying the settings so that the same IP address is always assigned when the printer starts up
3. Set the IP address, the subnet mask, and the gateway address manually as needed.
When setting them manually, go back up the hierarchy by pressing [
procedure in
Even if you are using any one of DHCP, BOOTP, or RARP, specify the IP address, subnet mask, and
gateway address. If you cannot obtain information from the servers of DHCP, BOOTP, and RARP, the values
specified manually are used.
NOTE
When using DHCP, BOOTP, or RARP
You can select only one from RARP, BOOTP, or DHCP.
After the printer restarts, the values obtained from DHCP, BOOTP, and RARP are displayed.
(If the values were specified previously, they overwrite the obtained ones.)
4. Proceed to Step 7.
If You Selected [Manual] in Step 5
1. Select [IP Address Settings] using [
2. Select [IP Address], [Subnet Mask] and [Gateway Address] using [
3. [IP Address], [Subnet Mask] and [Gateway Address] are each set.
NOTE
How to enter values in [IP Address], [Subnet Mask] and [Gateway Address].
4. Proceed to Step 7.
7
Perform a hard reset or restart the printer.
After performing a hard reset or restarting the printer, the settings are effective.
NOTE
For details on a hard reset
See
"Canceling All the Jobs (Hard
Downloaded from ManualsPrinter.com Manuals
Downloaded from
www.Manualslib.com
"Configuring the Protocol
Settings"
"If You Selected [Manual] in Step
1. Press [
] and [
] to move the cursor to each field (an area separated by periods to enter
three-digit numbers) in which you want to enter respective values of the address.
(The numbers in the field blinks, allowing you to enter the value.)
2. Enter the value. (Pressing [
3. After entering values in all the fields, press [OK] to confirm the setting.
Reset)."
manuals search engine
] (
5."
] and [
], and then press [OK].
] increases the value and [
: Back), and then perform the
] and [
], press [OK].
] decreases the value.)
Advertisement
Table of Contents
