Table of Contents
Advertisement
Check to make sure that [SD Card] under the [Control Menu] is set to [On].
If [SD Card] is not displayed, see
If the [SD Card] is [Off], set it to [On] using the following procedure.
(1) Press [
(2) Select [Control Menu] using [
(3) Select [SD Card] using [
(4) Select [On] using [
(5) Hard reset or restart the printer.
Check that the SD card is not write-protected. If the card is write-protected, release the protection, and then
insert the card.
The above figure is a sample of Configuration Page. The contents may differ from the Configuration Page printed
by your printer.
Downloaded from ManualsPrinter.com Manuals
Downloaded from
www.Manualslib.com
"Removing SD
] (
: Settings).
] and [
] and [
manuals search engine
Card," remove the SD card, and then try to install it again.
] and [
], and then press [OK].
], and then press [OK].
], and then press [OK].
Advertisement
Table of Contents
