Samson Series 3730 Mounting And Operating Instructions page 107

1. Click on one of the folders in the left tree directory to view the parameter settings on the
right. Place the cursor over a data point to open a tool tip providing more information on
the parameter.
2. Double-click the required parameter to open a pop-up window to modify parameter set-
ting.
Right-click the required parameter to open pop-up window to modify parameter settings:
Modify
Opens pop-up window to modify parameter settings.
Read Uploads parameter value from device.
Write Downloads parameter value to device.
Default: ... Resets parameter to default setting (setting in gray to indicate that the
parameter value is the same as the default setting)
Min ...
Set parameter to the displayed minimum value.
Max ...
Set parameter to the displayed maximum value
Note: Refer to the code list (section 14 on page 75 onwards) for descriptions of each param-
eter. The code number assigned to a parameter is listed in the Comment column in
TROVIS-VIEW.
Settings in TROVIS-VIEW software
107
EB 8384-2 EN