Maintenance, Diagnostics And Troubleshooting; Maintenance And Service; Warning And Alarm Types - Danfoss VLT AAF006 Operating Instructions Manual

Maintenance, Diagnostics an...

8 Maintenance, Diagnostics and Troubleshooting

8.1 Maintenance and Service

Under normal operating conditions and load profiles, the
active filter is maintenance-free throughout its designed
lifetime. To prevent breakdown, danger, and damage,
examine the filter at regular intervals depending on the
operating conditions. Replace worn or damaged parts with
original spare parts or standard parts. For service and
support, refer to www.danfoss.com/contact/
sales_and_services/.

8.2 Warning and Alarm Types

8.2.1 Warnings
A warning is issued when an alarm condition is impending
or when an abnormal operating condition is present and
may result in the active filter issuing an alarm. A warning
clears by itself when the abnormal condition is removed.
8.2.2 Alarm Trip
An alarm is issued when the active filter is tripped, that is,
the active filter suspends operation to prevent filter or
system damage. After the fault condition is remedied, reset
the active filter. It is then ready to start operation again.
A trip can be reset in any of 4 ways:
•
Press [Reset] on the LCP.
•
Digital reset input command.
•
Serial communication reset input command.
•
Auto reset.
8.2.3 Alarm Trip-lock
An alarm that causes the active filter to trip-lock requires
that input power is cycled. The active filter logic continues
to operate and monitors status. Remove input power to
the active filter and correct the cause of the fault, then
restore power. This action puts the active filter into a trip
condition as described in chapter 8.2.2 Alarm Trip and may
be reset in any of the 4 ways.
MG90V302
Operating Instructions
Danfoss A/S © 09/2014 All rights reserved.
8 8
75