Table of Contents
Advertisement
Safety
2 Safety
2.1 Safety Symbols
The following symbols are used in this document:
WARNING
Indicates a potentially hazardous situation that could
result in death or serious injury.
CAUTION
Indicates a potentially hazardous situation that could
result in minor or moderate injury. It can also be used to
alert against unsafe practices.
NOTICE
Indicates important information, including situations that
can result in damage to equipment or property.
2.2 Qualified Personnel
Correct and reliable transport, storage, installation,
operation and maintenance are required for the trouble-
free and safe operation of the active filter. Only qualified
personnel are allowed to install or operate this equipment.
Qualified personnel is defined as trained staff, who are
authorised to install, commission, and maintain equipment,
systems and circuits in accordance with pertinent laws and
regulations. Additionally, the personnel must be familiar
with the instructions and safety measures described in this
document.
2.3 Safety Precautions
WARNING
HIGH VOLTAGE
Active filters contain high voltage when connected to AC
mains input. Failure to perform installation, start-up, and
maintenance by qualified personnel can result in death
or serious injury.
WARNING
DISCHARGE TIME
The active filter contains DC-link capacitors, which can
remain charged even when the filter is not powered.
Failure to wait the specified time after power has been
removed before performing service or repair work can
result in death or serious injury.
MG90V302
Operating Instructions
Voltage
[V]
380–480
High voltage can be present even when the warning indicator
Table 2.1 Discharge Time
WARNING
LEAKAGE CURRENT HAZARD
Leakage currents exceed 3.5 mA. Failure to ground the
filter properly can result in death or serious injury.
•
WARNING
EQUIPMENT HAZARD
Contact with rotating shafts and electrical equipment
can result in death or serious injury.
•
•
•
CAUTION
INTERNAL FAILURE HAZARD
An internal failure in the filter can result in serious injury
when the filter is not properly closed.
•
Danfoss A/S © 09/2014 All rights reserved.
Output Current
[A]
190–400
lights are off.
Ensure correct grounding of the equipment by
a certified electrical installer.
Ensure that only trained and qualified
personnel perform installation, start up, and
maintenance.
Ensure that electrical work conforms to national
and local electrical codes.
Follow the procedures in this document.
Before applying power, ensure all safety covers
are in place and securely fastened.
2
Minimum waiting
time
(minutes)
20
7
2
Advertisement
Table of Contents
Need help?
Do you have a question about the VLT AAF006 and is the answer not in the manual?
Questions and answers