Lldp Configuration Examples; Basic Lldp Configuration Example - H3C SR8800 Configuration Manual

LLDP configuration examples

Basic LLDP configuration example

Network requirements
As shown in
Enable LLDP on the ports of Router A and Router B to monitor the link between Router A and Router B and
the link between Router A and the MED device on the NMS.
Figure 55 Network diagram
Configuration procedure
Configure Router A:
1.
# Enable LLDP globally.
<RouterA> system-view
[RouterA] lldp enable
# Enable LLDP on GigabitEthernet 4/1/1 and GigabitEthernet 4/1/2 (you can skip this step
because LLDP is enabled on ports by default), and set the LLDP operating mode to Rx.
[RouterA] interface gigabitethernet 4/1/1
[RouterA-GigabitEthernet4/1/1] lldp enable
[RouterA-GigabitEthernet4/1/1] lldp admin-status rx
[RouterA-GigabitEthernet4/1/1] quit
[RouterA] interface gigabitethernet 4/1/2
[RouterA-GigabitEthernet4/1/2] lldp enable
[RouterA-GigabitEthernet4/1/2] lldp admin-status rx
[RouterA-GigabitEthernet4/1/2] quit
Configure Router B:
2.
# Enable LLDP globally.
<RouterB> system-view
[RouterB] lldp enable
# Enable LLDP on GigabitEthernet 4/1/1 (you can skip this step because LLDP is enabled on ports
by default), and set the LLDP operating mode to Tx.
[RouterB] interface gigabitethernet 4/1/1
[RouterB-GigabitEthernet4/1/1] lldp enable
[RouterB-GigabitEthernet4/1/1] lldp admin-status tx
[RouterB-GigabitEthernet4/1/1] quit
Figure 55, the NMS and Router A are located in the same Ethernet.
145