Figure 8-3 Connect LANs through a dedicated line
Frame Relay Configuration Task List
Complete the following tasks to configure frame relay:
Configuring DTE
Side Frame Relay
Configuring DCE
Side Frame Relay
Enabling the Trap Function
The configurations for an NNI interface are similar to those for a DCE interface, except that the
interface types are different. When configuring an NNI interface, see
Relay.
If one endpoint of a link is configured as an NNI interface, the peer endpoint must also be
configured as an NNI interface.
Configuring DTE Side Frame Relay
Configuring Basic DTE Side Frame Relay
Follow these steps to configure DTE side frame relay:
To do...
Enter system view
Enter the view of the interface
connecting to the Frame Relay
network
Task
Configuring Basic DTE Side Frame Relay
Configuring Frame Relay Address Mappings
Configuring a Frame Relay Local Virtual Circuit
Configuring a Frame Relay Subinterface
Configuring Basic DCE Side Frame Relay
Configuring Frame Relay Address Mappings
Configuring Frame Relay Local Virtual Circuit
Configuring Frame Relay Subinterface
Configuring Frame Relay Switching
Use the command...
system-view
interface interface-type
interface-number
8-115
Remarks
Required
Required
Required
Optional
Required
Required
Required
Optional
Optional
Optional
Configuring DCE Side Frame
Remarks
—
—