Configuring Broadcast-Based Ntp Associations - Cisco Catalyst 9400 System Management Configuration Manual

Configuring Broadcast-Based NTP Associations

Step 5
Configuring Broadcast-Based NTP Associations
To configure broadcast-based NTP associations, perform this procedure:
Procedure
Step 1
Step 2
Step 3
Step 4
Step 5
System Management Configuration Guide, Cisco IOS XE Bengaluru 17.4.x (Catalyst 9400 Switches)
18
Command or Action
end
Example:
Device(config)# end
Command or Action
enable
Example:
Device> enable
configure terminal
Example:
Device# configure terminal
interface interface-id
Example:
Device(config)# interface
gigabitethernet1/0/1
[no] ntp broadcast [version number] [key
key-id] [destination-address]
Example:
Device(config-if)# ntp broadcast version
2
[no] ntp broadcast client
Example:
Administering the Device
Purpose
Returns to privileged EXEC mode.
Purpose
Enables privileged EXEC mode.
Enter your password if prompted.
Enters global configuration mode.
Configures an interface and enters interface
configuration mode.
Enables the interface to send NTP broadcast
packets to a peer.
• number: NTP version number. The range
is 1 to 3. By default, version 3 is used.
• key-id: Authentication key.
• destination-address: IP address of the peer
that is synchronizing its clock to this
switch.
Use the no form of this command to disable the
interface from sending NTP broadcast packets.
Enables the interface to receive NTP broadcast
packets.