Ipsec Sa Idle-Time - HP 5920 Command Reference Manual
Hide thumbs
Also See for 5920:
- Command reference manual (607 pages) ,
- Configuration manual (424 pages) ,
- Fc and fcoe configuration manual (257 pages)
Table of Contents
Advertisement
When IKE negotiates IPsec SAs, it uses the local lifetime settings or those proposed by the peer,
whichever are smaller.
An IPsec SA can have both a time-based lifetime and a traffic-based lifetime. The IPsec SA expires when
either lifetime expires. Before the IPsec SA expires, IKE negotiates a new IPsec SA, which takes over
immediately after its creation.
Examples
# Configure the global IPsec SA lifetime as 7200 seconds.
<Sysname> system-view
[Sysname] ipsec sa global-duration time-based 7200
# Configure the global IPsec SA lifetime as 10240 kilobytes.
[Sysname] ipsec sa global-duration traffic-based 10240
Related commands
display ipsec sa
•
sa duration
•
ipsec sa idle-time
Use ipsec sa idle-time to enable the global IPsec SA idle timeout function and set the idle timeout. If no
traffic matches an IPsec SA within the idle timeout interval, the IPsec SA is deleted.
Use undo ipsec sa idle-time to restore the default.
Syntax
ipsec sa idle-time seconds
undo ipsec sa idle-time
Default
The global IPsec SA idle timeout function is disabled.
Views
System view
Predefined user roles
network-admin
Parameters
seconds: Specifies the IPsec SA idle timeout, in the range of 60 to 86400 seconds.
Usage guidelines
This function applies only to IPsec SAs negotiated by IKE.
The IPsec SA idle timeout can also be configured in IPsec policy view or IPsec policy template view, which
takes precedence over the global IPsec SA timeout.
Examples
# Set the IPsec SA idle timeout to 600 seconds.
348
Advertisement
Table of Contents
