HP 5920 Command Reference Manual page 342

1 1.2.3.1
Table 44 Command output
Field
Src Address
Dst Address
Inbound SPI
Outbound SPI
Status
# Display the number of IPsec tunnels.
<Sysname> display ipsec tunnel count
Total IPsec Tunnel Count: 2
# Display information about all IPsec
<Sysname> disp lay ipsec tunnel
Tunnel ID: 0
Status: active
Perfect for ward secrecy:
SA's SPI:
outbound: 2000
inbound: 1000
outbound: 4000
inbou nd: 3000
Tunnel:
local address:
rem ote address:
Fl ow:
Tunnel ID: 1
Status: active
Perfect for ward secrecy:
SA's SPI:
outbound: 6000
inbound: 5000
outbound: 8000
inbou nd: 7000
Tunnel:
local address: 1.2.3.1
2.2.2.2
Description
Source IP address of the IPsec tunnel.
For IPsec SAs created by using IPsec profile
Destination IP address of the IPsec tunnel.
For IPsec SAs created by using IPsec profiles, "–" is dis
Valid SPI in the inbound direction of the IPsec tunnel.
If the tunnel uses two sec
displayed in two lines.
Valid SPI in the outbound direction of the IPsec tunnel.
If the tunnel uses two sec
displayed in two lines.
Stateful failover status of the IPsec SA: active o
Currently, "active" is displayed for all cases.
tunnels.
(0x000007d0)
(0x000003e8)
(0x00000fa0)
(0x00000bb8)
(0x00001770)
(0x00001388)
(0x00001f40)
(0x00001b58)
330
5000 6000
7000 8000
s, "–" is displayed in this field.
urity protocols, two SPIs in the inbound direction are
urity protocols, two SPIs in the outbound direction are
r backup.
[AH]
[AH]
[ESP]
[ESP]
[AH]
[AH]
[ESP]
[ESP]
active
played in this field.