Table of Contents
Advertisement
6. By default all necessary steps to replace a printhead are selected.
NOTE
If you only want to place a new printhead you must deselect [Remove printhead].
If you only want to prime a printhead you must deselect [Remove printhead] and [Place
printhead].
7. Tap on [Start].
8. Wait while the print system prepares the selected printhead(s) for removal.
9. You can now follow the steps in the wizard, or, for more detailed information, follow the steps
below.
NOTE
From this point you can also follow the video instruction. After that, proceed with step
number 30.
https://vimeo.com/oceitcdoctrans/review/130428499/d8ec8925f5
Chapter 9 - Maintain the print system
Replace printheads
231
Advertisement
Table of Contents
