Cleaning Water Separator; Lubricating Grease Fitting [2Wd Model] - Kubota M5660SUH Operator's Manual

BCleaning Water Separator
To avoid personal injury or death:
A Be sure to stop the engine before cleaning the
water separator.
This job should not be done in the field, but in a clean
place.
1. Close the fuel cock.
2. Unscrew the retainer ring and remove the cup, and
rinse the inside with kerosene.
3. Take out the element and dip it in the kerosene to
rinse.
4. After cleaning, reassemble the water separator,
keeping out dust and dirt.
5. Bleed the fuel system.
(See "Bleeding Fuel System" in "SERVICE AS
REQUIRED" in "PERIODIC SERVICE" section.)
(1) Fuel cock
(2) Retainer ring
(3) Cup
(A) "CLOSE"
(1) O ring
(2) Element
(3) Spring
(4) Red float
(5) Cup
(6) Retainer ring
BLubricating Grease Fitting [2WD Model]
Detach the cover, and apply bearing grease.
(1) Front wheel hub cover
PERIODIC SERVICE 79