Checking Brake Pedal; Checking Gauges, Meter And Easy Checker(Tm); Checking Head Light, Hazard Light Etc; Checking Seat Belt And Rops - Kubota BX2350D Operator's Manual

3. Undo the slide hose hooks and draw away the slide
hose.
4. Detach the radiator screen, and then remove all the
foreign material.
(1) Slide hose
(2) Slide hose hook
(1) Radiator screen
A Panel and radiator screen must be clean from debris
to prevent engine from overheating and to allow good
air intake for air cleaner.
A Be sure to reinstall the panel on the pillar completely
to prevent the invasion of dust.
A Be sure to stop the engine to avoid personal injury and
to allow good air intake for air cleaner.
BChecking Brake Pedal
1. Inspect the brake pedals for free travel, and smooth
operation.
2. Adjust if incorrect measurement is found:
(See "Adjusting Brake Pedal" in "EVERY 100 HOURS"
in "PERIODIC SERVICE" section.)
(A) "UNDO"
(B) "DRAW AWAY"
(A) "DETACH"
PERIODIC SERVICE
BChecking Gauges, Meter and Easy
Checker(TM)
1. Inspect the instrument panel for broken gauge(s),
meter(s) and Easy Checker(TM).
2. Replace if broken.
BChecking Head Light, Hazard Light etc.
1. Inspect the lights for broken bulbs and lenses.
2. Replace if broken.
BChecking Seat Belt and ROPS
1. Always check condition of seat belt and ROPS
attaching hardware before operating tractor.
2. Replace if damaged.
BChecking and Cleaning of Electrical
Wiring and Battery Cables
To avoid personal injury:
A A loosened terminal or connector, or damaged
wire may affect the performance of electrical
components or cause short circuits. Leakage
of electricity could result in a fire hazard, a
dead battery or
components.
A Replace damaged
promptly.
A If a fuse blows soon after replacement, DO NOT
USE A LARGER THAN RECOMMENDED FUSE
OR BYPASS THE FUSE SYSTEM.
A Many wiring connections are protected by
waterproof plugs, plug and unplug these
connections carefully and make sure they are
sealed correctly after assembly.
A Accumulation of dust, chaff and spilled fuel
deposits around the battery, electrical wiring,
engine or exhaust system are fire hazards.
CLEAN THESE AREAS BEFORE STARTING
WORK.
To avoid premature electrical malfunctions DO
NOT APPLY high pressure water directly to
battery, wiring,
components or instrument panel.
Inspect the following regularly:
1. Check wiring for chafed or cracked insulation.
2. Check wiring harness clamps. Replace if necessary.
3. Check connectors and terminals for looseness,
contamination or
connections.
4. Check instrument panel for correct operation of
switches and gauges.
Consult your KUBOTA Dealer regarding maintenance,
diagnosis and repair.
57
damage to electrical
wires or connections
connectors, electrical
overheated (discolored)