Timing Recording; Motion Based Recording; Sensor Based Recording; Disk Management - Vitek VT-TTAR810 User Manual

Transcendent DVR Series
7.4.2

Timing Recording

Timing Recording: the system will record automatically according to the schedule.
Set the timing record schedule of each camera. See 7.3 Schedule Setting for details.
7.4.3

Motion Based Recording

Motion Based Recording: the system will start motion based recording when motion appears
in the setup schedule. The setup steps are as follows:
Set the motion based recording schedule of each camera. See 7.3 Schedule Setting for
details.
Enable motion and set the motion area of each camera. See 9.2.1 Motion Configuration for
details.
The camera will start motion based recording once you finish the above settings.
7.4.4

Sensor Based Recording

Set the sensor based recording schedule of each camera. See 7.3 Schedule Setting for
details.
Set the NO/NC type of sensor, enable the sensor alarm and then check and configure the
"Record". See 9.1 Sensor Alarm for details.

7.5 Disk Management

Click StartàSettingsàDiskàDisk Management to go to disk management interface. You
can view the DVR's disk number and disk status and so on in the interface. Click "Formatting"
button to format the HDD.
Note: 1. A new HDD needs to be formatted for normal use.
2. For normal use of a HDD which has been used in another DVR, if the DVR is of the same
model as the new DVR, please import the configuration file of the old DVR to the new DVR or
format the HDD; if the models of the two DVRs are different, please format the HDD.
7.5.1

Storage Mode Configuration

Click StartàSettingsàDiskàStorage Mode to go to the interface as shown below.
51