Startup; Shutdown; Remote Control - Vitek VT-TTAR810 User Manual

startup and shutdown are crucial to expending the life of your device.
2.1.1

Startup

Connect the display device to the VGA/HDMI interface of the DVR.
Connect the mouse and power. The device will boot and the power LED will turn blue.
A WIZARD window will pop up (you should select the display language the first time you
use the DVR). Refer to 3.1 Startup Wizard for details.
2.1.2

Shutdown

Power off the device by using remote controller or mouse.
By remote controller:
Press Power button. This will take you to a shutdown window. The unit will power off
after clicking "OK" button.
Disconnect the power.
By mouse:
Click StartàShutdown to pop up the Shutdown window. Select "Shutdown" in the
window. The unit will power off by clicking "OK" button.
Disconnect the power.

2.2 Remote Control

Uses two AAA size batteries.
Open the battery cover of the remote control.
Insert batteries. Please observe the polarity (+ and -).
Replace the battery cover.
Key points to check in case the remote doesn't work.
1. Check batteries polarity.
2. Check the remaining charge in the batteries.
3. Check IR control sensor for any masking.
If it still doesn't work, please try a new remote control, or contact your dealer.
There are two kinds of remote controls. The interface of remote control is shown as below.
Button
Power Button
Record Button
14
Transcendent DVR Series
Function
Turns unit on and off
To start recording