Vitek VT-TTAR810 User Manual page 21

same local network with DVR and then click
to add all the cameras in the list. Click
delete all the added cameras.
Click to edit the found IP camera as shown on the below left. Input the new IP address,
subnet mask, gateway and the password of the camera. Click "OK" to save the settings.
Click to edit the added camera as shown on the above right. Input the new camera name,
IP address, port, username and the password of the camera. You can click "Test" to test the
effectiveness of the inputted information. Click "OK" to save the settings. You can change the
camera name only if it's an analog camera or the added IPC is online. Click "Next" to continue.
Disk Settings. You can view the disk number, disk capacity of the DVR and serial number,
R&W status of the disk. Click "Formatting" to format the disk. Click "Next" to continue.
Transcendent DVR Series
to add the found camera. Click "Add All"
to delete the added camera. Click "Delete All" to
20