Ø
System
The module covers the functions of Basic Configuration (see 11.2 Basic Configuration for
details), Device Information (see 11.7 View System Information for details), Log Information
(see 11.6 View Log for details) and Configuration File Import&Export (see 11.5 Backup and
Restore for details) and so on.
4.1 Signal Access Set
Click StartàSettingsàCameraàManage CameraàSignal Access Set to go to the
interface as shown below.
There are two types of analog signals: TVI and AHD. If the access signal is TVI, you should
check TVI in the following interface to show the camera image; if you check AHD, then there
will be no image or the image has no color. The default selection of the signal is Auto. If you
check Auto, then the image of the camera will be shown regardless of the access signal type.
LITE: if you check LITE the resolution will change from 1920 x 1080 to 960 x 1080
This will allow you to record at 30fps
4.2 Add/Edit Camera
4.2.1
Add Camera
The network settings of the DVR should be set before adding IP camera (see 11.1.1 TCP/IPv4
Configuration for details).
Refer to the pictures below. Click Add Camera in the setup panel or
corner of the preview window to pop up the "Add Camera" window as shown below. You can
quickly add or add the IP camera manually.
4 Camera Management
Transcendent DVR Series
26
in the top right