Cruise Setting; Ptz Protocol Setting - Vitek VT-TTAR810 User Manual

Transcendent DVR Series

6.3 Cruise Setting

Click StartàSettingsàCameraàPTZàCruise to go to the interface as shown below.
Ø Add Cruise
Click in the camera list on the right side of the interface to display the cruise information
of the dome and then click
window are similar to that of the PTZ control interface; please see 6.1 PTZ Control Interface
Introduction for details.
Ø
Edit Cruise
Select the camera and cruise in the "Cruise" interface. Input the a cruise name and then click
to save the cruise name. Click "Add Preset" to add preset to the cruise. Click
delete the preset from the cruise. Click one preset in the preset list and then click
move down the preset and click
click to stop it.
Ø
Delete Cruise
Click in the camera list on the right side of the interface to display the cruise information
of the dome and then click

6.4 PTZ Protocol Setting

Click StartàSettingsàCameraàPTZàProtocol to go to the interface as shown below.
You can set the protocol, baud rate and address of the analog dome in the interface. Please
to add cruise. The operations of the "Add Cruise"
to move up the preset. Click
on the top right corner of the cruise to delete the cruise.
43
to
to
to start the cruise and