Wsw38 (V.34 Transmission Settings) - Ricoh HL-F1 Field Service Manual

• Selector 1: Printout of the stored image data of an unsent document onto an error report
This selector determines whether or not to print out the 1st-page image data of a document onto the
error report if the document image data stored in the temporary memory cannot be transmitted
normally.
• Selector 2: Erasure of the stored image data of an unsent document at the time of the subsequent in-
memory message transmission
If in-memory message transmission fails repeatedly when selector 1 is set to "1," the temporary memory
will be occupied with image data. Setting selector 2 to "1" will automatically erase the stored 1st-
page image data of an unsent document at the time of the subsequent in-memory message transmission
only when recording paper or toner runs out.

WSW38 (V.34 transmission settings)

Selector No.
1
Setting of the equalizer
2
3 Sending level of guard tone at phase 2
Stepping down the transmission speed at
4
fallback each
Automatic control of modem's EQM gain
5
for proper transmission
6
speed choice
Redialing when a communications error
7
occurs
8 Detection of CED for stopping CNG
Function
Firmware Switches (WSW)
Setting and Specifications
No. 1 2
0 X : Automatic
1 0 : Fixed to 4 points
1 1 : Fixed to 16 points
0: Normal - 7 db 1: Normal
0: 2400 bps 1: 4800 bps
No. 5 6
0 0 : For higher transmission speed than
the current setting
0 1 : No change from the current setting
1 0 : For lower transmission speed than
the current setting
1 1 : For further lower transmission than
the setting made by 1, 0
0: ON 1: OFF
0: ON 1: OFF
5
195