Wsw18 (Function Setting 3) - Ricoh HL-F1 Field Service Manual

• Selector 7: Non-ring reception
Setting this selector to "1" makes the machine receive calls without ringer sound if the Ring Delay is
set to 0.

WSW18 (Function setting 3)

Selector No.
1 Not used.
2
Detection enabled time for CNG and no
tone
3
4
Not used.
5
6 Registration of station ID
7
Tone sound monitoring
8
• Selectors 2 and 3: Detection enabled time for CNG and no tone
After the line is connected via the external telephone or by picking up the handset of the machine, the
machine can detect a CNG signal or no tone for the time length specified by these selectors.
The setting specified by these selectors becomes effective only when selector 8 on WSW20 is set to
"1."
• Selector 6: Registration of station ID
Setting this selector to "0" permits the registration of station ID for Austrian and Czech models.
• Selectors 7 and 8: Tone sound monitoring
These selectors set monitoring specifications of the tone sound inputted from the line.
Function
Firmware Switches (WSW)
Setting and Specifications
-
No. 2 3
0 0 : 40 sec.
0 1 : 0 sec. (No detection)
1 0 : 5 sec.
1 1 : 80 sec.
-
0: Permitted 1: Prohibited
No. 7 8
0 X : No monitoring
1 0 : Up to phase B at the calling station
only
1 1 : All transmission phases both at the
calling and called stations
5
181