Table of Contents
Advertisement
9 SHOCK ABSORBER, SWINGARM
9.12
84
B03061-01
Removing the spring
B04460-10
B04461-10
–
Remove the spring. (
p. 84)
–
Disassemble the damper. (
–
Disassemble the piston rod. (
–
Disassemble the seal ring retainer. (
–
Check the damper. (
p. 89)
–
Remove the heim joint. (
–
Install the heim joint. (
–
Assemble the seal ring retainer. (
–
Assemble the piston rod. (
–
Assemble the damper. (
–
Install the spring. (
p. 100)
Condition
The shock absorber has been removed.
–
Clamp the shock absorber into the vise.
Guideline
Use soft jaws.
–
Measure and note the spring length while the spring is under
tension.
–
1
Loosen screw
.
–
Turn the adjusting ring until the spring is completely without
tension.
Holding wrench (90129051000) (
–
2
Remove lock ring
.
–
3
Remove spring retainer
–
4
Remove washer
.
p. 85)
p. 87)
p. 86)
p. 90)
p. 91)
p. 91)
p. 92)
p. 94)
p. 371)
.
Advertisement
Table of Contents
