Inner Shaft Assembly - SRAM Reverb Stealth Service Manual

200 (A2) & 400 (B1) Hour Service
Inspect each part for scratches. Do not scratch any sealing surfaces
when servicing your suspension. Scratches can cause leaks.
When replacing seals and o-rings, use your fingers or a pick to remove
the seal or o-ring. Spray isopropyl alcohol on each part and clean with
a clean lint-free shop towel.
Apply only SRAM® Butter grease to all Reverb parts, seals, and o-rings.
Remove the inner shaft piston o-rings.
1
Apply SRAM Butter grease to new o-rings and install them onto, and
into, the inner shaft piston.
Do not scratch the inner shaft piston with the pick.
Apply a liberal amount of SRAM Butter grease to the inside of a new
2
internal seal head assembly.
Install the internal seal head assembly onto the inner shaft, threaded
end first. Slide the internal seal head on the inner shaft until it stops
against the inner shaft piston.
I n n e r S h a f t A s s e m b l y
NOTI CE
NOTI CE
Pick
Pick

Inner Shaft Assembly

31