Upper Post Disassembly - SRAM Reverb Stealth Service Manual

2 0 0 ( A 2 ) & 4 0 0 ( B 1 ) H o u r S e r v i c e U p p e r P o s t D i s a s s e m b l y
Clamp the upper post head into the vise with flat soft jaws.
1
Remove the top cap assembly from the upper post and discard the top
cap assembly.
Insert a 1.5 mm hex wrench into one of the cross holes in the IFP tube.
2
Use pliers to carefully pull the IFP tube out of the upper post and
remove it from the post. Use your hand to guide the IFP tube straight
out of the upper post using care not to scratch the inside of the upper
post with the hex wrench.
Wipe the outer surface of the IFP tube and set it aside on a clean shop
towel.
NOTI CE
Do not scratch the inner surface of the upper post with the hex wrench.
Surface scratches can cause leaks and reduce performance.
If the IFP tube is scratched, it must be replaced.
1.5 mm Hex and Pliers

Upper Post Disassembly

26