Inner Shaft Installation - SRAM Reverb Stealth Service Manual

200 (A2) & 400 (B1) Hour Service I n n e r S h a f t I n s t a l l a t i o n
Clamp the upper post head back into the vise and flat soft jaws.
1
Reverb Hydraulic Fluid
Wrap a shop towel around the top of the upper post. Pour Reverb™
hydraulic fluid into the IFP tube until the fluid overflows into the upper
post and is level with the top of the upper post.
Use your finger to remove any bubbles from the surface of the fluid if
bubbles are visible.
Wrap a shop towel around the upper post to absorb displaced
2
hydraulic fluid.
Insert the inner shaft piston into the fluid and IFP tube.
B1: Push the seal head down into the upper post and thread it into the
upper post by hand.
A2: Push the seal head down and slowly thread the seal head just
enough to allow the o-ring to displace fluid. Unthread the seal head
and wipe the excess fluid away from the o-ring. Slowly thread the seal
head into the upper post making sure the o-ring does not protrude
from the upper post.
NOTI CE
Confirm the o-ring has not protruded from the upper post before
proceeding.

Inner Shaft Installation

33