SRAM Reverb Stealth Service Manual page 47

Hose barb: Thread the hose barb into the poppet valve cover. Use a
3
7 mm open end wrench to hold the hose barb in position and tighten
the poppet valve cover.
Connectamajig™ Hose Coupler (pictured in Step 2): Connect the hose
coupler to the Connectamajig coupler. Use your fingers to push the
Connectamajig hose coupler into the Connectamajig coupler until
it stops.
Thread the hose coupler into the Connectamajig coupler by turning
the coupler collar clockwise. Use a 6 mm open end wrench to hold the
hose fitting and tighten the Connectamajig coupler collar to.
This concludes service for the RockShox® Reverb™ Stealth adjustable height seatpost.
The Reverb Stealth hydraulic remote system must be bled before the seatpost can be reinstalled and used. Refer to the 'Reverb Stealth and
Reverb Hydraulic Hose Replacement and Remote System Bleed' manual, available at www.sram.com/service, for bleed and seatpost installation
procedures.
10 mm 3.4-4.5 N•m (30-40 in-lb) 7 mm
9 mm 1.1-2.9 N•m (10-26 in-lb) 6 mm
Connect to Seatpost 47