Poppet Valve Installation - SRAM Reverb Stealth Service Manual

200 (A2) & 400 (B1) Hour Service
A specific amount of Reverb™ hydraulic fluid must be removed from the
1
inner shaft before the poppet valve is installed. Consult the chart below
and set the fluid level height for your Reverb Stealth configuration on
the suspension fluid level gauge tool.
Reverb Stealth B1
Travel (mm)
100
125
150
170
Reverb Stealth A2
Travel (mm)
355 / 100
380 / 125
420 / 100
420 / 125
430 / 150
Insert the oil level adjuster into the inner shaft and draw excess fluid
2
from the inner shaft by pulling the syringe plunger. When fluid is no
longer pulled from the inner shaft into the syringe, remove the oil level
adjuster tool from the inner shaft.
Remove each poppet valve o-ring from the poppet valve.
3
Install new o-rings onto the poppet valve and apply SRAM® Butter
grease to each new o-ring.
Do not apply grease to the area between the upper poppet piston and
the o-ring just below it. Grease on the shaft under the large poppet
piston o-ring will limit movement when the remote actuator is pressed.
Use a clean shop towel to wipe away any excess grease from under
the large poppet o-ring.
P o p p e t V a l v e I n s t a l l a t i o n
Set fluid gauge to this length
(± 0.5 mm)
141
166
191
211
Set fluid gauge to this length
(± 0.5 mm)
186.5
186.5
251.5
226.5
211.5
NOTI CE
RockShox® Oil Level Adjuster
RockShox Oil Level Adjuster
Pick
Do not apply grease in this area

Poppet Valve Installation

35