Table of Contents
Advertisement
S u p e r D e l u x e C o i l A s s e m b l y a n d B l e e d
1
Thread the outer compression tool onto the inner compression tool
until the ends are flush.
Note: There are two lengths of inner compression tools. Use the tool
that best fits your shock length when installed on the Counter Measure
wrench.
2
Install the Counter Measure wrench onto the the damper shaft
sealhead. Make sure the wrench does not obstruct the bleed port in
the sealhead.
Install the Counter Measure compression tool onto the damper
assembly, with the tab on the compression tool inserted into the notch
in the wrench.
3
Install the spring retainer between the compression tool and the shaft
eyelet.
4
Turn the Counter Measure compression tool counterclockwise until it
stops and the damper is fully extended.
Outer
Compression
Tool
Counter Measure Wrench
Spring Retainer
Super Deluxe Coil Assembly and Bleed
Inner
Compression
Tool
Counter Measure Compression Tool
33
Advertisement
Table of Contents
