200 Hour Service; Shock Assembly And Bleed - SRAM RockShox SIDLuxe 2024+ Service Manual

2 0 0 H o u r S e r v i c e
1
Clamp the damper body into the SIDLuxe Body Vise Block.
Tighten the vise firmly enough so that the IFP cannot move in the
damper body. Check this by using your finger to push on the IFP.
If the IFP does move, use a shock pump to push out the IFP, and then
reset it to the depth specified in the table.
Do not overtighten the vise so that the damper body gets crushed.
The SIDLuxe Body Vise Block holds the IFP in place. Failure to use
the vise block when clamping the damper body into the vise may
result in improper IFP height. Improper IFP height can cause the
damper to fail.
2 Wrap a clean shop towel around the damper body.
Pour new Maxima PLUSH 7wt Suspension Oil into the damper body
until it is level with the top.
Maxima PLUSH 7wt Suspension Oil is backwards compatible with
RockShox 7wt suspension oil.
3 Make sure that the compression ball is removed from the Make sure that the compression ball is removed from the
seal head/air piston. seal head/air piston.
With the seal head/air piston positioned at the end of the damper shaft, With the seal head/air piston positioned at the end of the damper shaft,
install the seal head/air piston onto the damper body. install the seal head/air piston onto the damper body.
Do not press down on the shaft eyelet or damper shaft while Do not press down on the shaft eyelet or damper shaft while
installing the seal head; this can move the piston/shaft assembly, installing the seal head; this can move the piston/shaft assembly,
causing too much fluid to displace out of the damper body. causing too much fluid to displace out of the damper body.
Fluid will be displaced out of the bleed port.
S h o c k A s s e m b l y a n d B l e e d
NOTI CE
SIDLuxe Body Vise Block
Maxima PLUSH 7wt Suspension Oil

Shock Assembly and Bleed

47