Remove the top cap assembly from the upper post and discard it.
5
Spray isopropyl alcohol onto the upper post and inner shaft assembly
and wipe them with a clean shop towel.
Apply a liberal amount of SRAM® Butter grease around the inside of a
6
new top cap assembly and onto the seals.
Install the new top cap assembly, dust wiper seal end first, onto the
upper post assembly over the seal head. Slide the top cap assembly
down until it is positioned below the upper post key slots.
Ensure the dust wiper seal slides over the seal head without folding the
outer lip of the seal.
Install a new o-ring and bushing over the poppet valve housing
7
assembly and onto the seal head. Pinch the bushing to secure it
around the seal head and o-ring.
NOTI CE
Top Cap and Seal Head Bushing Replacement
21