Remote Lever; Hose Barb Replacement (Optional) - SRAM Reverb Stealth Service Manual

R e m o t e L e v e r
H o s e B a r b R e p l a c e m e n t ( O P T I O N A L )
Replace the remote hose barb only if it is damaged from impact.
If the hydraulic hose assembly is removed from the bicycle, refer to the 'Reverb™ Stealth and Reverb Hydraulic Hose Replacement and Remote System
Bleed' manual at www.sram.com/service
Spare Parts catalog at www.sram.com/service.
If Reverb hydraulic fluid leaks from the remote lever while under pressure or in use, the remote lever assembly must be replaced.
Use wire cutters to cut the cable tie used to secure the remote lever to
1
the bicycle handlebar.
Hold the hydraulic hose near the hose barb. Rotate the Reverb remote
2
lever counterclockwise and unthread the hose from the remote
hose barb.
for installation procedures. For a list of available Reverb Stealth hydraulic hose kits, refer to the RockShox®
N OTIC E
Wire Cutters Standard Remote
Needle Nose Pliers Standard Remote
Needle Nose Pliers Reverb 1x Remote
Wire Cutters Reverb 1x™ Remote

Remote Lever

42