Table of Contents
Advertisement
2 0 0 H o u r S e r v i c e
When replacing seals and o-rings, use your fingers or a pick to remove
the seal or o-ring. Spray isopropyl alcohol on each part and clean with
a rag. Apply grease to the new seal or o-ring. Only use RockShox®
Dynamic Seal Grease when servicing RockShox shocks.
To prevent damage to the shock use aluminum soft jaws and position
the eyelet in the vise so that the adjustment knobs are clear of the
vise jaws.
Inspect each part for scratches. Do not scratch any sealing surfaces
when servicing your suspension. Scratches can cause leaks.
Install the IFP, flat side up, into the IFP reservoir. Use a metric caliper or
1
ruler to push the IFP into the reservoir to a depth of 33 mm.
Super Deluxe™ RC3 Only: Install the compression assembly into the
2
reservoir mount. Push the compression assembly into the reservoir
until it stops.
Check that the compression lever is still in the unlocked (min) position
and the compression needle is sticking up.
Thread the IFP reservoir onto the eyelet. Tighten the IFP reservoir to
3
8 N·m (70 in-lb).
Install the crowfoot onto the torque wrench at a 90° angle to the
handle to ensure an accurate torque reading.
S h o c k A s s e m b l y a n d B l e e d
N OTICE
33 mm
31 mm
8 N•m (70 in-lb)
Shock Assembly and Bleed
27
Advertisement
Table of Contents
