Hydraulic Hose; Connect To Seatpost - SRAM Reverb Stealth Service Manual

H y d r a u l i c H o s e
5 0 / 2 0 0 / 4 0 0
There are two Reverb™ Stealth hydraulic hose types: 1) Hose barb, and 2) Connectamajig™. Follow the procedure in step 2 for the hose type on your
Reverb Stealth.
Use wire cutters to cut the cable tie used to secure the remote lever to
1
the bicycle handlebar.
Clamp the seatpost into a bicycle work stand. Position the bicycle
2
under the seatpost. Place a shop towel under the seatpost and hose to
absorb any hydraulic fluid that may drip.
Push the hydraulic hose into the frame hose port as needed.
Do not allow Reverb hydraulic fluid to come into contact with any brake
components. Contaminated brake components can compromise brake
performance, may cause brake failure, and can lead to serious injury
and/or death.
Do not pull the hydraulic hose out of the frame if there is tension at the
hose. This can cause damage to the hydraulic hose.
u r S e r v i c e
H o
⚠ WARNI NG
NOTI CE
C o n n e c t t o S e a t p o s t
Wire Cutters Standard Remote
Wire Cutters Reverb 1x™ Remote

Hydraulic Hose

46