Twisted Hobbys CRACK PITTS Assembly Manual page 33

Double check the length, and Repeat for the other side.
The next step will require Blenderm
orientation of the bosses, adjust as
and Welders. Although not required, it
needed and wick CA into the other end.
is highly recommended. Cut 4 strips
Snap the links into the gang horns.
that are approx 1.50" long.
Let the glue tack up for about 5 Locate the motor you will use and it's
The Blenderm tape will wrap around
each leg of the motor mount and attach minutes than apply the tape tabs. associated hardware.
to the the fuselage. Apply a skim coat of Again, one tab for each motor mount
Welders where the tape will contact, leg.
this gives a much stronger bond.
page 33
Rev: 2015.09.18.v01a