Advertisement
Also squeeze some Welder into the slot
Install the stiffener into the fuselage
Wipe away any extra glue with a paper
in the fuselage.
from the same side that you applied the
towel, and again, only one pass.
glue from.
Multiple passes will ruin the printed
graphics.
Locate the two wings, wing struts and
With your hobby knife remove the tabs
Check for squareness in the area of the
stiffeners and adjust if necessary. Set
wood spars as shown. Wing spars are
and scrap material from the slot
the assembly aside some where safe to
approx 23.6 inches long and the spars
cutouts of each of the wing.
dry... stand it on it's nose like what was
for the struts are approx 5.9 inches
long.
done previously.
page 14
Rev: 2015.09.18.v01a
Advertisement
Need help?
Do you have a question about the CRACK PITTS and is the answer not in the manual?
Questions and answers