Twisted Hobbys CRACK PITTS Assembly Manual page 32

Repeat the process with the other side,
again making sure that the servo and
control surface are centered.
With tape or other means, make sure
the upper wing's ailerons or level.
Rev: 2015.09.18.v01a
Snip off any extra length of the control
rod. Leave about 1/4" past the end of
the adjustable link.
With the nose of the airframe over the
edge of a table to clear the aileron's
servo, make sure the bottom ailerons
are ush to the table and check that
the snap links link up with the holes.
Aileron gang control rod will is next.
Locate the longer thick rods, four snap
links and four 1/2" long pieces of
shrink tubing. Heat shrink the ends on
like before, but NO GLUE at this time.
It may be necessary to trim the rods a
little to get the exact length, just slide
the link and tubing off, snip, and slide
back on. Once happy with the length,
wick some CA into the tubing ends.
page 32