Advertisement
Once happy with the tment of the
Slide the piece together. Assembly
Sight down the front of the airframe
upper and lower wings, the bottom
should be done on a nice at surface.
and make sure that every thing is nice
wing will be attached rst. Apply
Note that the tail skid bump helps to
and square and level.
Welders to all the mating surfaces. Note
position the fuselage at the correct
avoid glue in the servo hole.
angle, and nose should hang off table.
Put some Welders into the slots and the
Install the wing strut. Use a square to
Wing struts are next. Note that they
lean towards the front of the aircraft.
mating area just behind and in front of
position the strut square to the surface
the slot.
of the wing.
page 24
Rev: 2015.09.18.v01a
Advertisement
Need help?
Do you have a question about the CRACK PITTS and is the answer not in the manual?
Questions and answers