Twisted Hobbys CRACK PITTS Assembly Manual page 13

Stick the longer of the two pieces of
wood thru the reward slot in a diagonal
fashion, right at the intersection of the
two fuselage pieces.
Press the wood stiffener into position as
shown, adjusting it's position up or
down as needed to match the exact
length of the slot in the foam.
Rev: 2015.09.18.v01a
Position so that the length of wood
matches the approx length of the slot in
the foam.
Make sure the stiffener is centered in
the foam and wipe away any extra glue
that is left on the surface of the
fuselage pieces. Use a paper towel and
only make one pass.
Apply a thin coat of Welders to both
sides of the exposed wood stiffener.
Also squeeze some Welders into the
slots.
Apply a thin coat of Welders to both
sides of the shorter fuselage stiffener.
page 13