Advertisement
Starting with the aileron control rod
With a heat gun, hair dryer or lighter,
Apply a drop of CA to each end of the
(shorter thick rods), position the snap
shrink the tubing. Use caution, the
shrink tubing and let it wick in.
link and a piece of tubing as shown.
snap links are easily damaged from too
much heat.
Slide the free end of the control rod
Snap the plastic link into the outer hole
Spray with Kicker. Repeat for the other
aileron control rod as well as the two
thru the hole of the adjustable link on
of the aileron servos horn. In this case
long thin tail control push rods.
the aileron control surface.
snap in from underneath in the view
above. Don't worry about the extra rod
length or set screw at the moment.
page 29
Rev: 2015.09.18.v01a
Advertisement
Need help?
Do you have a question about the CRACK PITTS and is the answer not in the manual?
Questions and answers