Software Installation - GE ReadyToProcess WAVE 25 Operating Instructions Manual

4 Installation

4.3 Software installation

4.3 Software installation
About this section
This section describes how to perform a complete UNICORN 7.0 installation on a stand-
alone workstation (Full installation). Instructions on how to configure an e-license, define
a system, and set up a system printer are also included.
Note:
Additional information about software installation and configuration is available in the
UNICORN Administration and Technical manual.
In this section
Section
4.3.1 Install UNICORN software
4.3.2 Configure an e-license
4.3.3 Define the system
90
For other types of installations, contact your GE representative for support.
This includes network installations when you want to access the
ReadyToProcess WAVE 25 system from several client computers or control
more than one system from a single computer, or to run the system from a
third-party controller.
ReadyToProcess WAVE 25 Operating Instructions 29009597 AD
See page
91
94
101