Attach The Cellbag Bioreactor - GE ReadyToProcess WAVE 25 Operating Instructions Manual

5 Operation
5.1 Set up the system

5.1.4 Attach the Cellbag bioreactor

5.1.4 Attach the Cellbag bioreactor
Instructions
Follow the instructions below to attach the Cellbag bioreactor to the tray.
Note:
Note:
Step
1
2
112
When using a Cellbag bioreactor that only covers half of the tray in single
mode, such as a 10 L bag on Tray 20, position the bag on the left side of the
tray.
In dual mode, ensure that each Cellbag bioreactor is centrally positioned on
the respective grey heating pad. Weight measurement resolution will be
compromised if the bioreactor is not correctly placed.
Action
Push the bag clamp openers in the upper corners of the tray downwards.
This opens the upper bag clamps.
Note:
For a Cellbag bioreactor that covers the whole tray, open both bag clamps.
In dual mode or with a bioreactor that covers only half the tray, only one
clamp needs to be opened.
Insert the upper Cellbag rod into the opened bag clamp.
ReadyToProcess WAVE 25 Operating Instructions 29009597 AD