Label Profile - CAB EOS1 Configuration Manual

30 5 Test Functions
5.8

Label Profile

The Label profile function carries out a longer label advance. It saves the values measured by the label sensor
here and then prints them out in a diagram.
The printout is used to check label detection in conjunction with the optical properties of the label medium.
The printout occurs using the heat level and print speed specified in the Setup > Print param. menu.
Notice!
i
The printout of the diagram occurs without taking the label gaps into consideration. This is why endless
media are most suitable for the printout.
 Select the label sensor to be tested in the menu Setup > Print param.  "4.1.3" on page 13.
 Load the label medium to be tested into the printer.
 Start Offline menu.
 Select Test > Label profile.
The printer performs a longer label advance. The label sensor measures the transparency/reflection capacity of
the label material here. The message Insert appears in the display once the advance is complete.
 Insert printable medium (labels, endless paper) which extends across the entire printing width.
 If the printout is to occur using thermal transfer printing, insert transfer ribbon with the maximum width.
 Start the diagram printout with Continue.
The printout can be cancelled with
Mon Sep 26 13:26:04 2011
1
EOS1/300
Firmware V4.02 (Sep 26, 2011) - #170110417590
2
3
Peripheral device : None
4
50 mm/s - Gap Sensor 32 (23-46), Max 704
5
71.35mm - σ² 0.002mm²
Fig. 16
No. Information
1 Date and time of the printout
Device type
Version and creation date of the firmware
Serial number of the PCB CPU
Firmware version and serial number of the label sensor
2 Coordinate in the direction of paper flow at which the label start was detected
3
Type of peripheral device connected
4 Print speed, method of label detection (Gap sensor / Bottom-reflect sensor)
and service information of label adjustment
5 Average value and variation of label distances
Table 15
.
Label profile
Information in Label profile
30