Loading The Label Roll; Inserting Labels Into The Transport Module - CAB MACH 4.3S/200B Operator's Manual

4 Loading Material
12
4.1.2

Loading the Label Roll

1
2
3
4
Figure 10
 Open the cover and remove the roll retainer (3) with the margin stops (1,5) from the printer.
 Press the lever (6) and remove the margin stop (5) from the roll retainer (3).
 Slide the label roll (4) onto the roll retainer (3) and respectively the adapter (2).
Ensure that the labels on the unwound strip are facing up irrespective of the wind direction..
 Put the margin stop (5) onto the roll retainer (3) and slide it with lever (6) pressed against the label roll.
The label roll is centered automatically.
 Place the roll retainer into the printer.
4.1.3

Inserting Labels into the Transport Module

1
2
3
4
Figure 11
 Turn aside the control panel.
 Press the release button (7) to unlatch the print module and lift it up.
 Feed the labels forwards under the deflector (5) to the label outlet (4) through the control panel.
 Move the label guides (3) apart with the setting wheel (2) until the labels can pass between them. Press the label
strip down, and move the label guides (3) back up against the edges of the label.
 Move the print module down and press evenly on the two marked surfaces (6) so that the unit snaps into place
on both sides.
 For peel-off mode  4.3 on page 14.
For tear-off and cutting mode:
Lock the control panel and close the cover.
Loading the label roll
Inserting labels into the transport module
5
6
2
6
5
7
3
12
6