Loading Labels - CAB MACH4 Operator's Manual

12 4 Loading Material
4.1.2

Loading Labels

The method of loading label rolls applies to both thermal paper labels and labels that are printed by means of a
transfer ribbon.
1
2
2 3
4
5
Fig. 4
1. Open the cover and hinge down the control panel.
2. Take the roll hub (10 - fig.1) out of the holder slots (11 - fig.1) in the printer.
3. Press down the lever (3) on the edge stop 2 (2) and pull the edge stop off from the label core (4).
4. If necessary, mount or dismount the adapter,  4.1.1 on page 11. Slide the label roll over the label core (4) and
place it against the edge stop 1 (1) so that it is guided by the adapter (5) and the flange of the edge stop. In so
doing, ensure that the labels on the unwound strip are facing up irrespective of the wind direction.
5. Remount the edge stop 2 (2) on the label core (4) and, with the lever pressed (3), slide it against the label roll. In
so doing, the label roll is automatically set in the center line by the edge stops. Place both edge stops against the
label roll, and release the lever (3).
6. Place the roll hub back into the holder slots on the printer. Ensure that the rounded surfaces of the edge stops are
facing forward,  fig. 1.
7. Press the release button (14 - fig.1) and hinge the print module up.
8. Feed the label stock forwards under the deflector (6) and over the print roller (9) until it projects about 15 cm out
of the printer.
9. Move the label guides (8) apart with the setting wheel (7) until the labels can pass between them. Press the strip
label down, and move the label guides (8) back up against the edges of the label.
10. Hinge the print module down and press evenly on the two marked surfaces so that the unit snaps in on both
sides.
11. For peel-off mode  4.3 on page 14.
For tear-off and cutting mode:
Feed the label stock out through the label outlet in the control panel (18 - fig.1). Hinge up the control panel and
close the cover.
Roll holder and path of the label stock
6
7
8
9
12