Wiring Burglary, Panic And Smoke Detector Devices To Zones 1-9; Figure 3-8: Telephone Line Connections - Honeywell VISTA-128BP Installation And Setup Manual

VISTA-128BP/VISTA-250BP Installation and Setup Guide
TERMINALS
ON CONTROL

Wiring Burglary, Panic and Smoke Detector Devices to Zones 1-9

The maximum zone resistance is 100 ohms for
zones 1 and 8, and 300 ohms for all other
zones (excluding the 2K EOL resistor).
To wire burglary and panic devices to zones 1-9,
connect sensors/contacts to the hardwire zone
terminals (10 through 23). See Figure 3-9. Connect
N.C. and N.O. devices as follows:
3-6
WWW.DIYALARMFORUM.COM
Incoming
Handset Telco Line
26 27 28

Figure 3-8: Telephone Line Connections

Red Jumper
ZONE 2 ZONE 3
10 11 12 13 14 15
ZONE 1
+ +
-
N.C. N.C.
N.O. N.O.
2k EOLR 2k EOLR
+
+ -
Fire
Usage
N.C.
SMOKE
N.O.
N.C.
Burg.
Usage
2k EOLR
N.O.
Zone resistance (Excluding EOLR):
ZONE 1,8: 100 OHMS MAXIMUM
2k EOLR
ALL OTHER ZONES: 300 OHMS MAXIMUM
Figure 3-9: Wiring Connections for Zones 1-9
WWW.DIYALARMFORUM.COM
29 30
EARTH GROUND
DIRECT
CONNECT
CORD
RJ31X
JACK
PLUG
•
Connect N.C. devices in series with the high (+)
side of the loop. The 2K EOL resistor must be
connected in series with the devices, following the
last device.
•
Connect N.O. devices in parallel (across) the
loop. The 2K EOL resistor must be connected
across the loop wires at the last device.
ZONE 4 ZONE 5 ZONE 6 ZONE 7
16 17 18 19 20
+ +
-
N.C. N.C.
N.O. N.O.
2k EOLR 2k EOLR
+
-
N.C.
N.O.
2k EOLR
INCOMING TELCO LINE
TIP
PREMISES
RING
PHONES
ZONE 8 ZONE 9
21 22 23
+ - +
GLASS
BREAK
N.C.
N.C.
N.O. N.C.
2k EOLR
Zone response time:
ZONES 1-9: 350mSec-500mSec
ZONE 9: Also Programmable
for RS232 input