Wiring Inputs (Zones); Overview; Zone Wiring Types - Honeywell MAXPRO MPIP2000U Series Installation And Setup Manual

Honeywell MAXPRO Intrusion MPIP2000U/3000U Series
Port No. Protocol
123 UDP
443 TCP (TLS 1.2)

Caution!
For a secure network connection, please follow instructions for the
network and firewall as described in the MAXPRO Intrusion Security
Manual (doc. no. 800-25507).

Note
Trouble and tampering signalling is disabled while the system is in
Installer Mode. If you are on-line with the panel, but in Normal mode,
all alarms report immediately. All other reports are delayed until you
complete the session.
The keypads remain active when on-line with a control panel, but are
inactive during actual uploading or downloading sessions. The
keypads will indicate that the system is running in Installer Mode: the
text Installer service mode appears in the top left corner of the
display.
3.8

Wiring Inputs (Zones)


Note
This section applies to the zones on the MPI Control Panel and the
connected IB2 bus devices. It is not applicable to V-Plex devices. For
wiring V-Plex devices, see Installing V-Plex Devices on page 101.
3.8.1

Overview

The control panel offers 10 zones (sensor inputs). Zones 9 and 10 can be used
for 2-wire smoke detectors.
3.8.2

Zone Wiring Types

Wire the required zones (F, G, and R on page 34) or terminate them using
resistors.
800-23044 Rev. A draft_11
Function
Used to synchronise time
MAXPRO Cloud communication
ISOM
Installation and Setup Guide
39