Honeywell VISTA-128BP Installation And Setup Manual page 116

VISTA-128BP/VISTA-250BP Installation and Setup Guide
Scheduling
Commands
Access Control
Commands
Panel Linking
Commands
B-2
WWW.DIYALARMFORUM.COM
Installer-Programmed Schedule Events = Installer Code + [#] + 80 (Installer or Master
Only).
Temporary Schedule Editing = User Code + [#] + 81 (Installer, Master, Manager Only).
Extend Closing Window = User Code + [#] + 82 (Installer, Master, Manager Only).
End User Output Device Programming = User Code + [#] + 83.
Activate Access Relay for Current Partition = User Code + 0.
Request to Enter/Exit = User Code + [#] + 73.
Request to Enter/Exit at Access Point = User Code + [#] + 74 + Access Point Number.
Change Access Point State = User Code + [#] + 75 + Access Point + State.
Perform a Test of the VistaKey Module = Installer Code + [#] + 78.
Perform an Access Control Card Function = User Code + [#] + 79.
Only user 001 – 050 can perform panel linking.
Activate Single-Partition, Single-Panel Mode = User Code + [#] + 86.
Exit Single-Partition, Single-Panel Mode = User Code + [#] + 85.
Activate Multi-Partition, Multi-Panel Mode = User Code + [#] + 87.
Exit Multi-Partition, Multi-Panel Mode = Enter [0].
Activate Multi-Panel View Mode = User Code + [#] + 88.
Exit Multi-Panel View Mode = Enter [0].
WWW.DIYALARMFORUM.COM