Rear Bench Seat - Mercedes-Benz Sprinter Operating Instructions Manual

Folding seat without sidebag
Folding seat with sidebag
X
Remove key : from the partition sliding
door.
X
Folding seat without sidebag: pull grip of
catch ; in the direction of the arrow and fold
seat cushion = up or down.
Folding seat with sidebag: press grip of
catch ; in the direction of the arrow and fold
seat cushion = up or down.
X
Release grip ; of seat cushion = in the cor-
responding end position.
X
Move the seat cushion = until it engages.
Grip ; of the catch must lie completely on
the seat frame.
Rear bench seat (crewbus)
G
WARNING
If the rear bench seat is not installed as descri-
bed or an unsuitable rear bench seat is instal-
led, the seat belts may not provide protection
as intended. There is an increased risk of
injury.
Install the rear bench seat as described. Only
use rear bench seats that have been approved
for your vehicle by Mercedes-Benz.
Keep the rear bench seat mounting shells in the
vehicle floor free from dirt and foreign objects.
Locking levers on the anchorages of the bench seat
X
To remove the rear bench seat: swing all
levers : of the bench seat completely
upwards.
The bench seat moves back into the seat
mounting shells on the vehicle floor.
X
Lift the bench seat upwards out of the mount-
ing shells.
Do not exceed the maximum permissible
i
number of seats for models registered as
passenger vehicles.
X
To install the rear bench seat: observe the
prescribed installation position of the bench
seat.
Install the two-seat bench seat only on the
driver's side.
X
Check mounting shells ; on the vehicle
floor.
X
Position the bench seat in the direction of
travel in corresponding mounting shells ;.
Seats
83
Z