Hazard Warning Lamps - Mercedes-Benz Sprinter Operating Instructions Manual

Hide thumbs Also See for Sprinter:
Table of Contents

Advertisement

Headlamp range adjustment
The headlamp range control allows you to adjust
the cone of light from the headlamps to suit the
vehicle load. The cone of light changes if the
seats are occupied or if the load compartment is
loaded or unloaded. This can impair visibility and
dazzle oncoming traffic.
You can only adjust the headlamp range while
the engine is running.
i
The headlamp range is automatically set for
vehicles with bi-xenon headlamps and for
vehicles with ENR (electronic level control).
X
Turn headlamp range control : to the cor-
responding position. The road should be illu-
minated from 40 m to 100 m and the dipped-
beam headlamps must not dazzle oncoming
vehicles.
If the vehicle is unladen, select position g.
Cornering light function
The cornering light function improves the illu-
mination of the road over a wide angle in the
direction you are turning, enabling better visi-
bility in tight bends, for example.
The cornering lamps switch on automati-
cally if:
you are travelling at a speed of less than
R
40 km/h and you switch on a turn signal or
turn the steering wheel.
you are travelling at a speed of between
R
40 km/h and 70 km/h and you turn the steer-
ing wheel.
The cornering lamp may remain lit for a short
time, but is automatically switched off after no
more than 3 minutes.
i
If reverse gear is engaged the lamp on the
opposite side of the vehicle switches on
instead.

Hazard warning lamps

G
WARNING
The rear exterior light will be covered if you:
Open the rear doors by 90°.
R
Open the rear dropside.
R
The vehicle will then be difficult for other road
users to see or will not be seen by them at all,
particularly if it is dark or visibility is poor.
There is a risk of an accident.
You should therefore ensure in this and simi-
lar situations that the vehicle is visible from
the rear in accordance with the relevant
national regulations, by using the warning tri-
angle, for instance.
Hazard warning lamp switch
X
To switch on and off: press the £ hazard
warning lamp switch.
If you have indicated a turn while the hazard
warning lamps are switched on, only the turn
signal lamps on the side of the vehicle selected
will light up.
The hazard warning lamps switch on automati-
cally if:
an airbag is deployed.
R
you brake sharply and bring the vehicle to a
R
halt from a speed of more than 70 km/h.
If the hazard warning lamps have been switched
on automatically, press the £ hazard warn-
ing lamp switch to switch them off.
Exterior lighting
Z
91

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents