Overview - Mercedes-Benz Sprinter Operating Instructions Manual

Timer overview
Timer above the overhead control panel
Program column
:
G Sets preselection memory 1 – 3
Y
( page 124)
Sets weekday (Mon. – Sun.) (
Menu bar
;
y Switches immediate heating mode on
Y
and off ( page 123)
B Sets the programmed times
Y
( page 124)
Ñ Sets the day, time and the operating
Y
duration ( page 123)
ß Sets the heating level (
Display panel for: time, heating level and
=
operating duration
à Continuous operation mode active
ß Heating level set
Selects options in program column : or
?
menu bar ; (forwards)
Increases values
Confirms a selection or setting
A
Status bar
B
y Heating mode activated
Activates the timer
C
Cancels or ends settings in a menu
Selects options in program column : or
D
menu bar ; (backwards)
Reduces values
Activating the timer
The timer switches to standby mode after
10 seconds. The display goes off.
X
Press and hold the Ü button until the
menu bar appears in the display and the time
is shown.
Operating the auxiliary heating system
Setting the day, time and operating dura-
tion
You must reset the day, time, and default value
for the operating duration:
during initial operation
R
after a voltage supply interruption (e.g. if the
R
battery has been disconnected)
after a malfunction
R
You can find information on malfunctions in the
"Problems with the auxiliary warm-air heater"
section (
X
Press the Û or â button until the Ñ
symbol in menu bar ; flashes.
X
Press the b button.
In program column :, the day selected
flashes.
X
Press the Û or â button to set the
Y
page 123)
desired day.
X
Press the b button.
The day selected is stored. The hour setting of
the clock flashes.
X
In the same way, set the hour and subse-
quently the minutes, then confirm by pressing
the b button.
The time is stored. Program column : dis-
Y
page 124)
appears and the operating duration flashes.
i The operating duration set is the default set-
ting for immediate heating mode. You can set
the operating duration from 10 to
120 minutes or activate continuous opera-
tion.
X
Using the Û or â button, set the
minute value or select the à symbol for
continuous operation.
X
Press the b button.
The operating duration is stored. The time is
shown.
Switching immediate heating mode on
and off
X
To switch on: press the Û or â button
until the y symbol in the menu bar flashes.
X
Press the b button.
The operation duration flashes in the display.
i You can preset the default value that is
shown (
X
Using the Û or â button, set the
minute value (10 to 120) or select the à
symbol for continuous operation.
Y
page 125).
Y
page 123).
123
Z